Select Gas Detector

Brand -

  • Show more

Gas -

  • Show more
SKU: MCXL-XXXX-Y-XX

BW MicroClip XL Multi-Gas Detector

SKU: MCXL-XXXX-Y-XX

£387.96

Filtered: Resistant to silicone but mainly detects small gases like methane, propane and hydrogen.
Non Filtered: Detects more compounds, but struggles with heavy vapours like diesel and aviation fuel.

Description

BW MicroClip XL Multi-Gas Detector

Under this gas detector is the same bestselling BW MicroClip but has been redesigned and rebranded as the BW MicroClip XL Multi-Gas Detector and given a brand-new cutting-edge battery design, providing up to 18 hours of operation. Eight hours more than the preceding version.

The popularity of this portable gas monitor is not just due to its reliability, but also its lightweight, small design and single-button mode of operation, making it very easy to use, especially within confined spaces.

For a more robust solution, especially against the challenges of working in cold conditions, the BW MicroClip XL is ideal and comes with extended battery life.

You can configure the BW MicroClip XL gas detector to monitor combinations of the following: Hydrogen Sulphide (H2S), Carbon Monoxide (CO), Oxygen (O2) and Combustible LEL.

For more information, get in contact via the contact us form or call 02920 759 683.

Specifications

GASMEASURING RANGERESOLUTION
H2S0 -100 ppm1 ppm
CO0 – 500 ppm1 ppm
O20-30.0%0.1%
COMBUSTIBLE GASES
0-100% LEL1%
0-5.0% v/v0.1%
Size11.3 x 6.0 x 3.2 cm / 4.4 x 2.4 x 1.2 in
Weight190 g / 6.7 oz
Temperature-20 to +50°C / -4 to +122°F
Humidity0% – 95% RH (non-condensing)
AlarmsVisual, vibrating, audible (95 dB) • Low, High, TWA, STEL, OL (over limit)
TestsAudible/visual alarms on activation; sensors, battery and circuitry (continuous)
Typical Battery Life18 hours; recharges in less than 6 hours
Note: Approximately 20% capacity loss is normal with lithium polymer batteries after 500 charge cycles. Refer to the Operator’s
Manual for additional information.
User Options• Confidence beep
• Set STEL interval
• Sensor on/off
• Latching alarms
• Safe display mode
• Stealth mode
• Calibration lock
• Auto zero on start up
• O2 auto calibration on start up
• Set bump test interval
• Force bump test when overdue
RatingsIP68 – up to 45 minutes at 1.2 m (Honeywell BW™ MicroClip XL and X3)
EMI/RFI: Complies with EMC Directive 2004/108/EC
Certifications and ApprovalsCSA: Class I, Div. 1, Gr. A, B, C, D
ATEX: , II 1 G. Ex ia IIC T4 Ga
IECEx: Ex ia IIC T4 Ga
European Conformity
KTL (Honeywell BW™ MicroClip X3 certification in progress)
WarrantyFull two‑year (Honeywell BW™ MicroClip XL) or three‑year (Honeywell BW™ MicroClip X3) warranty including all sensors
Note: Battery is guaranteed to have 12 hour runtime during warranty period under normal operating temperature of
4°F / -20°C to 122°F / 50°C
Expected Service LifetimeFive years including all sensors* (Honeywell BW™ MicroClip X3 only)
*Note: Sensors do not contain consumable components and will typically reach the expected lifetime if used according to the instructions in the user manual. Please note that poisoned sensors are not covered by warranty.
Description

BW MicroClip XL Multi-Gas Detector

Under this gas detector is the same bestselling BW MicroClip but has been redesigned and rebranded as the BW MicroClip XL Multi-Gas Detector and given a brand-new cutting-edge battery design, providing up to 18 hours of operation. Eight hours more than the preceding version.

The popularity of this portable gas monitor is not just due to its reliability, but also its lightweight, small design and single-button mode of operation, making it very easy to use, especially within confined spaces.

For a more robust solution, especially against the challenges of working in cold conditions, the BW MicroClip XL is ideal and comes with extended battery life.

You can configure the BW MicroClip XL gas detector to monitor combinations of the following: Hydrogen Sulphide (H2S), Carbon Monoxide (CO), Oxygen (O2) and Combustible LEL.

For more information, get in contact via the contact us form or call 02920 759 683.

Technical Specification
Size: 11.3cm x 6cm x 3.2cm
Weight: 190g
Detection Range: H2S: 0-100 ppm. CO: 0-500 ppm. O2: 0-30% Vol. Combustible Gases: 0-100% LEL.
Battery: 18 Hours
Temperatures (Operating): -20 to 50C
IP Rating: IP68
Alarms: Visual, Vibrating, Audible
Approvals: CSA, ATEX, IECEx
Videos
FAQs
What gases does the BW MicroClip XL Multi-Gas Detector detect?

The BW MicroClip XL detects the following four gases:

  • O₂ (Oxygen)

  • LEL (Combustible gases, % Lower Explosive Limit)

  • CO (Carbon Monoxide)

  • H₂S (Hydrogen Sulphide)

How long does the battery last on a full charge?

Up to 18 hours under normal operating conditions. Charging time is typically around 4 to 6 hours.

Is the BW MicroClip XL Multi-Gas Detector ATEX certified?

Yes. It is ATEX, CSA, and IECEx certified, making it safe for use in potentially explosive atmospheres.

Can the BW MicroClip XL Multi-Gas Detector be used in confined spaces?

Yes, it’s commonly used for confined space entry due to its compact size, lightweight design, and ability to detect oxygen deficiency, toxic gases, and combustible gases.

Is it compatible with the IntelliDoX system?

Yes, the MicroClip XL can be used with Honeywell’s IntelliDoX docking system for automated bump testing, calibration, and data management.

Contact Us

Enquire about this product

Send us your questions about this product and we will endeavour to get back to you as soon as possible!

Product: BW MicroClip XL Multi-Gas Detector